Iei-integration AFL2-W15A-N270 v2.00 Manual do Utilizador descarregar pdf (Página 31)

AFL2-W15A-N270 Panel PC

Page 19

Figure 2-9: Internal Aluminum Cover Retention Screws

2.7 Jumper Settings

NOTE:

A jumper is a metal bridge used to

close an electrical circuit. It consists of

two or three metal pins and a small

metal clip (often protected by a plastic

cover) that slides over the pins to

connect them. To CLOSE/SHORT a

jumper means connecting the pins of

the jumper with the plastic clip and to OPEN a jumper means removing

the plastic clip from a jumper.

The following jumpers can be found on the motherboard installed in the AFL2-W15A-N270.

Before the AFL2-W15A-N270 is installed, the jumpers must be set in accordance with the

desired configuration. The jumpers on the AFL2-W15A-N270 motherboard are listed in

Table 2-2.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 140 141

Sem comentários

Iei-integration AFL2-W15A-N270 v2.00 Manual do Utilizador Página 31