Iei-integration IMBA-H610 Manual do Utilizador descarregar pdf (Página 67)

IMBA-H610 ATX Motherboard

Page 52

4.3 Jumper Settings

NOTE:

A jumper is a metal bridge used to close

an electrical circuit. It consists of two or

three metal pins and a small metal clip

(often protected by a plastic cover) that

slides over the pins to connect them. To

CLOSE/SHORT a jumper means

connecting the pins of the jumper with

the plastic clip and to OPEN a jumper means removing the plastic clip

from a jumper.

The hardware jumpers must be set before installation. Jumpers are shown in Table 4-1.

Description Label Type

AT/ATX power select JATX_AT1 2-pin header

Clear CMOS jumper J_CMOS1 3-pin header

USB power select jumpers USB_PWR2,

USB_PWR3,

USB_PWR4,

LAN1_USB01_PWR1,

LAN2_USB23_PWR1

3-pin header

Table 4-1: Jumpers

4.3.1 AT/ATX Power Select Jumper

Jumper Label: JATX_AT1

Jumper Type:

2-pin header

Jumper Settings:

See Table 4-2

Jumper Location:

See Figure 4-7

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 192 193

Sem comentários

Iei-integration IMBA-H610 Manual do Utilizador Página 67