Iei-integration IMBA-C2260-i2 Manual do Utilizador descarregar pdf (Página 81)

IMBA-C2260-i2 ATX Motherboard

Page 64

Step 5: Removing the iRIS-2400 module. To remove the iRIS-2400 module, push both

handles outward. The module is ejected by a mechanism in the socket.Step 0:

NOTE:

After installing the iRIS-2400 module, use LAN1_USB2 port to

establish a network connection. Please refer to Section

4.9 for IPMI

setup procedures.

4.4 mSATA Card Installation

To install an mSATA card, please follow the steps below.

Step 1: Locate the mSATA card slot. The location of the mSATA card slot is shown in

Chapter 3.

Step 2: Remove the retention screws. Remove the two retention screws secured on

the motherboard as shown in

9Figure 4-8.

Figure 4-8: Remove the Retention Screws for the mSATA Card

Step 3: Insert into the socket at an angle. Line up the notch on the card with the notch

on the connector. Slide the mSATA card into the socket at an angle of about 20º

(

9Figure 4-9).

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 226 227

Sem comentários

Iei-integration IMBA-C2260-i2 Manual do Utilizador Página 81