Iei-integration TDM_Series v2.01 Manual do Utilizador descarregar pdf (Página 73)

TDM Series Monitor

Page 59

Figure 6-6: Finish Installation

6.4 Change the Touch Screen Interface

If the touch screen interface must be changed from an RS-232 interface to a USB

interface or, from a USB interface to an RS-232 interface, the following steps must be

followed.

Step 1: Uninstall the touch screen driver

Step 2: Remove the interface cable i.e. remove the RS-232 cable or the USB cable

Step 3: Install the new cable i.e. install the USB cable or the RS-232 cable.

Step 4: Reinstall the driver CD as described above. Step 0:

6.5 Calibrating the Touch Screen

To calibrate the touch screen cursor with the motion of the touch screen pen (or finger),

please follow the steps below:

Step 1: Make sure the system is properly connected through an RS-232 or a USB

interface to the TDM Series monitor.

Step 2: Make sure the touch screen driver is properly installed.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 79

Sem comentários

Iei-integration TDM_Series v2.01 Manual do Utilizador Página 73