Iei-integration AFL2-12A-D525 Manual do Utilizador descarregar pdf (Página 53)

AFL2-12A-D525 Series Panel PC

Page 53

Step 3: To secure the bracket to the AFL2-12A-D525, insert the retention screws into the

screw holes and tighten them. Step 0:

4.9.3 Arm Mounting

The AFL2-12A-D525 is VESA (Video Electronics Standards Association) compliant and

can be mounted on an arm with a 100mm interface pad. To mount the AFL2-12A-D525 on

an arm, please follow the steps below.

Step 1: The arm is a separately purchased item. Please correctly mount the arm onto

the surface it uses as a base. To do this, refer to the installation documentation

that came with the mounting arm.

NOTE:

When purchasing the arm please ensure that it is VESA compliant and that

the arm has a 75 mm or 100 mm interface pad. If the mounting arm is not

VESA compliant it cannot be used to support the AFL2-12A-D525 flat bezel

panel PC.

Step 2: Once the mounting arm has been firmly attached to the surface, lift the flat bezel

panel PC onto the interface pad of the mounting arm.

Step 3: Align the retention screw holes on the mounting arm interface with those in the

flat bezel panel PC (

Figure 4-14).

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 179 180

Sem comentários

Iei-integration AFL2-12A-D525 Manual do Utilizador Página 53