Iei-integration AFL2-12A-D525 Manual do Utilizador descarregar pdf (Página 62)

AFL2-12A-D525 Series Panel PC

Page 62

Step 3: Insert the serial connector. Insert the DB-9 connector of a serial device into

the DB-9 connector on the RS-422/485 cable.

Step 4: Secure the connector. Secure the serial device connector to the external

interface by tightening the two retention screws on either side of the connector.

Step 5: The DB-9 connector pinouts are listed below.

Figure 4-25: DB-9 Connector

Pin RS-422 RS-485

1 TX- DATA-

2 TX+ DATA+

3 RX+

4 RX-

Table 4-4: DB-9 Connector Pinouts

Step 0:

4.10.4 USB Device Connection

There are two external USB 2.0 connectors. All connectors are perpendicular to the

AFL2-12A-D525. To connect a USB 2.0 or USB 1.1 device, please follow the instructions

below.

Step 1: Located the USB connectors. The locations of the USB connectors are shown

in Chapter 2.

Step 2: Align the connectors. Align the USB device connector with one of the

connectors on the bottom panel. See

Figure 4-26.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 179 180

Sem comentários

Iei-integration AFL2-12A-D525 Manual do Utilizador Página 62