Iei-integration IMB-H610A Manual do Utilizador descarregar pdf (Página 77)

IMB-H610 Micro-ATX Motherboard

Page 62

Step 3: Insert the DVI-I connector. Once the connectors are properly aligned with the

male connector, insert the male connector from the digital display device into the

female connector on the IMB-H610. See Figure 4-15.

Figure 4-15: DVI Connector

Step 4: Secure the connector. Secure the DVI-I connector from the digital display

device to the external interface by tightening the two retention screws on either

side of the connector.

4.6.3 LAN Connection

There are two external RJ-45 LAN connectors. The RJ-45 connectors enable connection

to an external network. To connect a LAN cable with an RJ-45 connector, please follow

the instructions below.

Step 1: Locate the RJ-45 connectors. The locations of the USB connectors are shown

in Chapter 3.

Step 2: Align the connectors. Align the RJ-45 connector on the LAN cable with one of

the RJ-45 connectors on the IMB-H610. See Figure 4-16.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 191 192

Sem comentários

Iei-integration IMB-H610A Manual do Utilizador Página 77